Excuse me ZCU106: What should I do if SCUI cannot work normally?

All Comments

• 

  Glen Posted on 2020/11/27 19:18:32

  Hello @ MSH

  SCUI cannot use the new version of CP210x USB to UART bridge VCP driver normally.

  I suggest you install the v6.7 driver for CP210x USB to the UART Bridge VCP driver.

  Please follow the procedure below:

  Please uninstall CP210x USB to the UART Bridge VCP driver of the PC.

  https://www.silabs.com/community/interface/knowledge-base.entry.html/2012/03/28/manually_uninstallt-w2i7 and install version 6.7 driver from the following link:

  https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers

  After reinstalling the driver, connect your motherboard to the PC and check the function of SCUI.

  Edit 1: The ZCU106 evaluation board supports the VITA 57.1 FPGA Mezzanine Card (FMC) specification.

  Please check whether your FMC card complies with the VITA 57.1 standard.

  Also tried to read all voltages and check the results

  Regards,

  Reply 0

  You need to log in to reply. Sign In | Sign Up

  • 

    Posted on 2020/11/27 23:17:24

    Glen Reply

    I tried all ports and checked the jumpers.

    But there is no change, and still get 0.0 volts.

    Best wishes!

    
    

    Reply 0

    You need to log in to reply. Sign In | Sign Up

• 

  Carl Posted on 2020/11/27 22:34:28

  The system controller sets VADJ_FMC to 1.8 V by default.

  You can try some other COM ports and see if you see the same problem?

  Please carefully read the ZCU106 board debugging checklist and verify:

  https://www.xilinx.com/support/answers/54013.html

  
  

  Reply 0

  You need to log in to reply. Sign In | Sign Up

• 

  Brant Posted on 2020/11/28 7:18:12

  From the ZCU106 schematic diagram, D15 LED is powered by MAX15301 PMBUS device (with U63 reference mark)

  Provide the power status of all the LEDs shown in the screenshot below.

  Reply 0

  You need to log in to reply. Sign In | Sign Up